Leeson
Leeson AC Definite Purpose Motor
Item #
6439191251
0.75 HP Boat Hoist Duty Motor, 1 phase, 1800 RPM, 115/230 V, 56C Frame, TENV
- UL recognized component listing and CSA certification ensures the product is safe for use.
- Double-shielded bearings extend the service life of the motor.
- Extended shaft with wrench flats for manual jogging of auger.
- Manual-reset thermal protector (as noted) protects against motor overload.
- High carbon alloy output shaft provides maximum strength and rigidity
- All needle bearing journals are precision ground after heat treating to provide maximum fit and finish
- Heavy duty industrial oil seals keep lubricant in and dirt out; Gears and bearings are splash lubricated with permanent, heavy duty gear oil; Run capacitor supplied at no additional cost for single phase designs
- Three phase and hi-torque single phase models include conduit box, other single phase models do not; These gearmotors are designed for mounting at any angle, but motor below the reducer should be avoided to prevent leakage of lubricant into the motor should the motor shaft seal fail
- Three phase and hi-torque single phase models include conduit box, other single phase models do not; These gearmotors are designed for mounting at any angle, but motor below the reducer should be avoided to prevent leakage of lubricant into the motor should the motor shaft seal fail
- Overhung load capacities shown are at center of output shaft; Optional conduit box available
Important Documents
| Manufacturer | Leeson |
|---|---|
| Horsepower | 0.75 |
| kW | 0.56 |
| Frequency | 60 Hz |
| Voltage | 115/230 |
| RPM Speed | 1725 |
| Phase | 1 |
| Enclosure | Totally Enclosed Non Ventilated |
| Current | 9.8/4.9 |
| Service Factor | 1.15 |
| Efficiency % | 72 |
| Power Factor | 68 |
| Duty | 15 Minute |
| Insulation Class | B |
| Design Code | N |
| KVA Code | K |
|---|---|
| Frame | 56C |
| Ambient Temperature | 40 C |
| Drive End Bearing Type | Ball |
| Drive End Bearing Size | 6203 |
| Opposite End Bearing Type | Ball |
| Opposite End Bearing Size | 6203 |
| UL | Recognized |
| CSA | Y |
| CE | Y |
| IP Code | 43 |
| Rotation | Selective Counterclockwise |
| Mounting Type | Rigid Base |
| Shaft Diameter | 0.625 |
| Motor Application | Boat Hoist Motor |